Grippers

SCHUNK EGU

SCHUNK EGU is a configurable electric gripper family. The necessary stroke, force setting and industrial network interface depend on the selected variant and the object being handled.

Product-specific engineering analysis

SCHUNK EGU is a configurable electric gripper family. The necessary stroke, force setting and industrial network interface depend on the selected variant and the object being handled.

A compliant part that sticks to the jaws

Soft packaging and elastomer parts introduce two opposite failure modes: too little force allows slip, while excess normal force compresses the part and may make it stick during release. In a workcell, record fingertip material, object deformation and the distance travelled during release.

Before buying the EGU variant, check the manufacturer's stroke and force envelope for the exact jaw geometry. The nominal opening width must include part-tolerance stack-up, and any external fingers change the mechanism's effective leverage.

Prove the chosen fieldbus configuration

EGU variants expose different industrial interfaces. Confirm the selected model, device description and controller compatibility before selecting PROFINET, EtherNet/IP or IO-Link. Run a timeout test with the gripper mid-motion and document whether the robot can safely recover without silently dropping the part.

When is an electric EGU better than a pneumatic parallel gripper?

An electric gripper can adjust positions and force through the interfaces offered by its selected variant. Pneumatic jaws may suit a simple high-cycle application with only open and closed states, but they require air supply and valve control. Compare the actual closure time, repeatability, electrical or air consumption and maintenance at the intended cycle count rather than relying on a general category preference.

The EGU family allows different stroke and force configurations; choose the exact variant from part width, finger extension and expected inertia. A long finger can introduce a moment that is absent from the nominal closing-force table. Include the application-specific permitted jaw geometry and contact surfaces in the design review.

What should a fieldbus timeout do to the gripped object?

Define behavior for a command sent during a network failure: should the fingers hold position, stop, or release under a supervised recovery sequence? Confirm the applicable device and interface documentation for PROFINET, EtherNet/IP or IO-Link variants. The cell should distinguish network state, motion complete and part present. Validate the result with actual hardware and a safe test fixture.

How can finger extensions invalidate an EGU force selection?

A custom jaw places contact farther from the gripper's guided fingers. This increases bending moment under the same object force and may reduce permissible gripping force at the workpiece. Consult the selected EGU variant's finger-load and stroke documentation before machining adapters. A force value on the actuator specification is not automatically the allowed load at the tip of a long extension.

Run a retention trial with the final fingers and the fastest allowed robot motion. Inspect jaw parallelism, mounting screw looseness and the part surface after each series. For a delicate plastic housing, compare the accepted part count at several force settings. The most reliable configuration may use shaped contact pads instead of greater clamping force.

Recorded specifications and configuration

Manufacturer
SCHUNK
Family and category
Universal parallel gripper · Grippers
Communication
PROFINET, EtherNet/IP, IO-Link
Power
24 V DC
Reported availability
Commercial
Product information checked
2026-07-10

Manufacturer-stated features

  • Electric universal gripper family
  • Configurable gripping force and stroke

Applications listed in this catalog: Industrial robots, Collaborative robots. These categories do not establish compatibility with an individual robot model or controller.

Product documentation

Compare within Grippers: Robotiq 2F-85 · OnRobot RG2